=====AquaMarina Build Photos=====
AquaMarina was made from a hull shell supplied by Bloodaxeboats and finished by [[people:phil Alderson]] in Aberdeen

{{boats:2681-2000xxxxa.jpg}}
  * Bow area with false floor in place and spiniker pole lying on top.

{{boats:2681-2000xxxxb.jpg}}
  * Kingt Post, bulkheaads and centerboard case

{{boats:2681-2000xxxxc.jpg}}
  * Looking aft at the corner peices that support the top of the side decks

{{boats:2681-2000xxxxd.jpg}}
  * Looking forward with the false floor in place.

{{boats:2681-2000xxxxe.jpg}}
  * Another forward view showing the king post.

{{boats:2681-2000xxxxf.jpg}}
  * Looking down on the king post.

{{boats:2681-2000xxxxg.jpg}}
  * The workshop, this picture does not show the I14 sail that hung above the boat stopping the dirt from falling from the roof down onto the boat.

{{boats:2681-2000xxxxh.jpg}}
  * Another view aft

{{boats:2681-2000xxxxi.jpg}}
  * Looking at the transom before the gantry went on.

{{boats:2681-2000xxxxj.jpg}} 
  * Close up of the one of the tubes that will make up the racks

{{boats:2681-2000xxxxk.jpg}} 
  * Rack Tubes agian

{{boats:2681-200104xx.jpg}}
  * Nearing completion, faired and ready for painting. The longtitudinal tubes were left off till the end to give more space in the workshop as it had now changed to a small garrage.

{{boats:2681-200107xx.jpg}}
  * Rigging up for the first time at the side of a road in weymouth

{{boats:2681-2003xxxxa.jpg}}
  * The original Gantry was too close to the water and the sticky out gudgions were failure prone. So it was cut off and replaced.

{{boats:2681-20030410.jpg}}
  * Much neater.


  * Ignore this (delete me on or after 3/7/2006)

{{tech:hr-tiller-a.jpg}}