AquaMarina Build Photos
AquaMarina was made from a hull shell supplied by Bloodaxeboats and finished by Phil Alderson in Aberdeen
- Bow area with false floor in place and spiniker pole lying on top.
- Kingt Post, bulkheaads and centerboard case
- Looking aft at the corner peices that support the top of the side decks
- Looking forward with the false floor in place.
- Another forward view showing the king post.
- Looking down on the king post.
- The workshop, this picture does not show the I14 sail that hung above the boat stopping the dirt from falling from the roof down onto the boat.
- Another view aft
- Looking at the transom before the gantry went on.
- Close up of the one of the tubes that will make up the racks
- Rack Tubes agian
- Nearing completion, faired and ready for painting. The longtitudinal tubes were left off till the end to give more space in the workshop as it had now changed to a small garrage.
- Rigging up for the first time at the side of a road in weymouth
- The original Gantry was too close to the water and the sticky out gudgions were failure prone. So it was cut off and replaced.
- Much neater.
- Ignore this (delete me on or after 3/7/2006)